Klark Technik - DN100 V2 Active DI Box

Klark Technik – DN100 V2 Active DI Box

Immaculately high headroom with a rich dynamic response and sonic clarity means every nuance of your signal is retained for crystal clear sound quality. Its increased headroom means that much higher level input signals can be accommodated without the need for an attenuating pad. Combined with very low noise input circuitry, the DN100 only requires a single -30 dB pad when connecting directly to amplifier outputs. This is a DI box designed to handle whatever you throw at it.

Please Enquire for Prices
Enquire
Category:

Technical Specification

  • Features
  • Active DI box with high-headroom design and +48 V phantom power for extended dynamic range
  • Fully transformer-isolated design ensures electrical separation between PA and stage equipment
  • Balanced line input on Neutrik* XLR and high impedance input and link output on 1/4″ TRS connectors
  • 20 dB input pad and earth lift switches
  • Aluminium extrusion casing with protective rubber corners
  • Compact and rugged design
  • Specifications
  • Inputs
  • Connectors: 2 x 1/4″ TRS and 3-pin XLR linked in parallel
  • Impedance: 1 MΩ nominal, balanced or unbalanced, 20 kΩ (XLR only)
  • Max input level: 35 dBu (with pad enabled)
  • Attenuator: 20 dB pad
  • Outputs
  • Connector: 3-pin XLR
  • Impedance: 50 Ω
  • Max output level: 15 dBu with 10 kΩ load
  • Min load: 600 Ω
  • System
  • Noise: -103 dBu, 22 Hz to 22 kHz unweighted, with input terminated by 10 kΩ resistor
  • Frequency response: 20 Hz to 20 kHz, ±1 dB, 10 kΩ load
  • Distortion (THD + N): Typically less than 0.005 @ 1 kHz, +10 dBu
  • Power Requirement
  • Voltage: +48 V phantom
  • Current consumption: less than 10 mA

Related products